Board Foot Calculator Desktop Header Logo
Калькулятор BD FT
Log Scaling Calculator

Калькулятор объёма бревен

Рассчитайте объём бревна в board feet по правилам Doyle, Scribner и International 1/4 — введите диаметр в вершине и длину.

Log Calculator

Enter log dimensions to estimate board foot yield

Measure inside bark

Optional - for taper calculation

Scaling Note: Measurements should be taken inside the bark at the small end. Log rules account for sawing waste and taper.

Doyle Rule

Formula: ((D-4)²/16) × L. Most conservative, favors buyers. Best for logs 12-28" diameter. Common in eastern US.

Scribner Rule

Based on diagram method. Moderate estimate. Most widely used lumber rule in the US, especially Pacific Northwest.

International 1/4"

Most accurate for all sizes. Accounts for 1/4" kerf. Favored for hardwoods and government timber sales.

Часто задаваемые вопросы

Which log rule should I use?
Doyle for small logs (12-28"), Scribner for general use, International for large logs or accurate estimates. Check local market standards.
Why do different rules give different results?
Each rule has different assumptions about sawing efficiency, kerf width, and taper. Doyle assumes high waste, International assumes efficient sawing.
How accurate are log scale estimates?
Typically ±10-15% of actual recovery. Factors include sawyer skill, grade requirements, defects, and equipment efficiency.

How to work out board feet for logs, in plain words

Formula depends on the log rule you choose. Doyle rule: board feet = ((diameter in inches minus 4) squared / 16) x length in feet. Scribner and International rules use different formulas in the calculator, because they assume different kerf width and sawing efficiency. A log scale result is an estimate of sawn lumber recovery, not a count of boards already cut.

Worked example: take a log 20 inches in diameter and 16 feet long. Doyle rule: ((20 minus 4) squared / 16) x 16 = (256 / 16) x 16 = 256 board feet. The same log gives about 272 board feet under the Scribner formula used on this page, and about 325.64 board feet under the International formula, so the rule you choose changes the answer by a large amount. Always record which rule was used, because a buyer and a seller using different rules will disagree even on the same log.

Common mistakes: measuring diameter at the wrong end, using small end diameter for one rule and large end diameter for another, ignoring taper, and treating a log scale result as exact. Measure diameter inside bark at the small end where your market requires it, and note defects, sweep, and rot separately.

Waste factor: log scale estimates are typically within about 10 to 15 percent of actual recovery, depending on sawyer skill, grade requirements, defects, and equipment. Do not order milling, drying, or transport on a log scale figure alone. Confirm the tally after sawing, and allow for kerf, slabs, edgings, and defect removal.

When to use this method: use this calculator for buying, selling, or valuing round logs and standing timber estimates. Use the lumber calculator after logs are sawn into boards, and the tree calculator for standing tree yield before felling.

Related log and timber calculators

These three tools cover the next step after log scaling: standing tree yield, sawn lumber board feet, and load weight.